Can Trailer Taillights be Converted to LED without Causing Dash Error Codes
Updated 11/04/2024 | Published 10/24/2024 >
Question:
I want to ADD LED taillights to my trailers existing incandescent tail lights. I know that LED conversion can throw codes/CEL/dash warning lights on some cars. I assume LED have a high resitance that the vehicle interprets as bad bulb. If that is the case, adding an LED to the existing low resistance filament bulb in parallel should not cause this problem. Or?
asked by: Volker
Expert Reply:
Hey Volker, so you can add LED taillights to your trailer and not have to worry about any of the issues that vehicles have. Trailer wiring circuits drawing less amperage due to using LED lights does not cause the same issues that vehicles have when this is done.
Product Page this Question was Asked From
Sealed, 4" Round, LED Trailer Stop/Turn/Tail Light, 3-Function, 10 Diode - Red w/ Clear Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement for Haulmark # 900200 Fender Marker Light on 10 x 5 Enclosed Trailer
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer
- Q&A: Replacement For Dometic AC 59516.331
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: How to Identify Capacity of Dexter Axle by Measuring it
- Q&A: Recommended Wiring Conversion for Semi Truck and Gooseneck Trailer with Electric Brakes
- Q&A: Replacement Shock for Dexter Axle 052-003-00
- Q&A: Finding a Hub for a Very Old Trailer with 6 Lug Bolt Pattern # 1779 inner and # 2788 Outer Bearings
- Q&A: Replacement Wheel Studs for Hub 22834
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Mount a Truck Bed Camper
- Article: Stability Control for Heavy Duty Vehicles


Volker
11/2/2024
Thank you, that helps greatly. Glad that the trailer/towing circuits of cars are not designed to be 'smart' as those on today's cars that are often very sensitive to changes in draw/resistance. I will proceed with adding two LED tail lights in parellel to the existing filament lights mounted higher up for visibility (in case I am using the rear storage box).