What Is The Weight Of The Caliber Pro Clamp CA57AJ?
Updated 12/22/2025 | Published 10/16/2024
Question:
what is the actual weight of this product? Would like to calculate my payload. thanks in advance.
asked by: Mark
0
Expert Reply:
Hello Mark, thanks for reaching out. The Caliber Pro Clamp # CA57AJ weighs about 12 lbs.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Caliber Clamp Pro Snowmobile Tie Down
- Snowmobile Trailer Parts
- Clamps
- 4 Inch Wide
- 46 Inch Long
- Caliber
more information >
Continue Researching
- Q&A: Replacement Hubs for 1997 FLOE Pro 100 Plus Snowmobile Trailer
- Q&A: What is the Measurement from the Top of the Bolt Hole to Bottom of Cast Head Coupler w/ Jack Hole?
- Q&A: Do Carry Something That Will Work for a Tie-Down Bar for a 1998 Floe Pro 100 Snowmobile Trailer?
- Q&A: Differences between Class III and Class IV Hitches
- Q&A: Replacement Galvanized Hub for a 2000 Floe Pro 1 Plus Single Axle Snowmobile Trailer
- Q&A: Replacement For 12,000 lb Drop Leg Jack
- Q&A: Can the Titan Aero 6000 Surge Brake Actuator Be Repaired Or Should It Just Be Replaced
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Wiring Diagrams
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: Best Tire Chains
Jesse M.
12/22/2025
Hey Mark, did the 12‑lb weight of the Caliber Pro Clamp help you figure out your payload numbers? Knowing how it worked out could help others planning their setups too.