Do You Have a Replacement Fuel Door for a Snowmobile Trailer?

Question

Question:

Hello I’m looking for a replacement gas door for a snowmobile trailer the rough opening in trailer is 12” x12” the overall size is 14 x14 . Prefer black but open to options. Thanks Dana

asked by: Dana D

0

Expert Reply:

Hey Dana! Sorry but we do not have a replacement gas door in that size. The largest is going to be the 6-7/8" x 6-3/8" B&B RV Multi-Purpose Fuel Hatch item # BM42MR.

The closest door we have to your dimensions is the Multi-Purpose Access Door - 14-1/2" Wide x 14-3/4" Tall - Black item # SE68VR or in white item # SE86VR.

expert reply by: Jerred H

0

Answer 1

Hello Michael, Congrats on the new 5th Wheel! What’s your favorite feature so far? Three words everyone likes to hear: "You are correct." And you are! Your pin box is indeed the Lippert Rhino. I’m not sure why Lippert doesn’t just put that…

view full answer...

Answer 2

The closest Go Power option to the Magnum Energy MM1212 Inverter Charger is the Go Power Industrial Pure Sine Wave Inverter Charger #34280055. This inverter/charger is rated for 2000 watts running and 4,000 watts surge/startup. This equals out to…

view full answer...

Answer 3

One thing to note when using a hitch extender like the etrailer, #e88YR, is that the tongue weight and towing capacity of your trailer hitch will be reduced by 50 percent due to the increased leverage that is placed on your trailer hitch from your…

view full answer...

Answer 4

The smoke and white covers that are on the Ventline roof vents are both going to let quite a bit of light into the trailer. However, due to the translucent nature of the smoke covers they would let more light in. Both would last about the same amount…

view full answer...

Answer 5

When choosing a Weight Distribution (WD) system you will want to find one with a Tongue Weight (TW) range that the Total Tongue Weight (TTW) of your towing setup falls in the middle of. To find the TTW of your towing setup you will need to add the TW…

view full answer...

Answer 6

Weight distribution systems place hundreds upon hundreds of pounds of upward force on a hitch receiver, so the weight distribution shank needs to be installed directly into the receiver without use of an extender like the #MPG544. Plus, due to the…

view full answer...

Answer 7

Hello James, There may be one option that works for you, depending on the current cutout of your FIC lock, though I couldn't find any dimensions of a tall FIC lock. If your door is between 1-1/4" to 1-1/2" thick and the cutout for the…

view full answer...

Do You Have a Replacement Fuel Door for a Snowmobile Trailer?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching