Can Caliber LowPro Glides Be Installed on Aluminum Trailer
Updated 12/22/2025 | Published 09/20/2024
Question:
Can these be installed on aluminum? Thanks.
asked by: Sam
0
Expert Reply:
Hi Sam; the screws that come with the Caliber LowPro Glides # CA26TJ are designed to be used with wood. However, you can use them on steel and aluminum if you drill a pilot hole first with an 11/64" drill bit.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Caliber MultiGlides for Snowmobile Trailers - 6-1/4" Wide x 60" Long - Qty 4
- Snowmobile Trailer Parts
- Traction Surface
- Glides
- 4 Pack
- 6-1/4 Inch Wide
- 60 Inch Long
- Caliber
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Where is etrailer Located and Are Our Prices in US Dollars?
- Q&A: Replacement Hubs for 4 Place Aluminum Newman Snowmobile Trailer With Dual Axles
- Q&A: Replacement ST145/R12 Tires and Wheels for 2012 Triton Trailer
- Q&A: Dimensions And Installation For The Caliber Snowmobile Grips Kit # CA46TJ
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Article: Trailer Wiring Diagrams
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Replacement Bearings, Hubs, and Brake Assemblies for a Apex Nano w/ 3,500 lbs Axles
- Q&A: Will Fulton Tandem Trailer Fender # F008583 Fit Shoreland'r Tandem Axle Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Change a Trailer Tire
Robin H.
12/22/2025
Hey Sam, how did drilling the pilot holes go when mounting the Caliber LowPro Glides on your aluminum surface? Your update could make it easier for the next person working with the same setup.