Is Roller Tube End Bar Support Sold Separately
Updated 01/12/2026 | Published 09/07/2024
Products Featured in This Question
Question:
Do you sell the end roller holder support to hex bar separate?
asked by: Jerry W
0
Expert Reply:
Hey Jerry, thanks for reaching out!
The Replacement Left-Side Head and Roll Bar for Solera RV Slide-Out Awnings # LC87FR comes as a whole kit and the only part that's separate is the Roller Tube Endcap # LC423751, but this is for the open-ended side.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Replacement Left-Side Head and Roll Bar for Solera RV Slide-Out Awnings - Black
- Accessories and Parts
- RV Awnings
- Head Parts
- Rollbars
- Head Assembly - Manual
- Solera Replacement
- Idler Head
- Black
- Lippert
more information >
Continue Researching
- Q&A: Instructions For Replacing Drive Head and Idler Head On a Solera Slide Out Topper Awning
- Q&A: Replacement Driver Head and Idler Head for Lippert Solera Slide Out Awning
- Q&A: RV Furnace Recommendation to Replace Atwood 2334DCLP
- Q&A: Replacement End Caps For Lippert Solera 1000 Series Slide Topper Awning
- Q&A: Replacement Drive Head And Roll Tube Assembly For Lippert Solera Awning
- Q&A: Will Solera 5000 Series Slide Toppers Fit On The Brackets From Older Solera Slide Topper Models
- Q&A: Parts Needed To Install Solera Awning Fabric On Slide-Out
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Performance Chips and Modules
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Trailer Wiring Diagrams
Lazer S.
1/12/2026
Hey Jerry, did the roller tube endcap end up working for your Solera slide-out awning? Knowing how it fit could help others looking for the same replacement part.