Dimensions Of The Optronics 7-Pole Blade to 5-Pin Delphi Connector Strain Relief

Question

Question:

What size is the strain relief?

asked by: Roman W

0

Expert Reply:

Hi Roman,

The strain relief at the connector of the # OPT42ER is approximately 3-1/4" in length and would require a 3/4" hole to pass through. If you have any other questions please feel free to comment below.

expert reply by: Kevin C

0

Answer 1

Bill, it looks like the 7-Pole Blade to 5-Pin Delphi Connector #OPT42ER is only available with the backup camera option.

view full answer...

Answer 2

To install the Optronics LED Trailer Lights, part #STL22RB, you will need to use the Straight 3-Wire Pigtail, part #A45PB. The Red wire of #A45PB will carry the turn signal function, the Black wire is for running lights, and White is ground. If you…

view full answer...

Answer 3

You may have a short in the wiring or the ground is bad for your license plate lights. You can use a Test Light #PTW2993 to determine if you have power getting all the way to the light socket. This is generally the prong on the bottom of the bulb…

view full answer...

Answer 4

Typically people will let the breakaway battery run the breakaway system and then would use the accessory battery to power the interior lights etc. This tends to work the best since your breakaway battery needs to always be charged and interior…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Christian, welcome to the world of RV-ing! So in addition to the Roadmaster Nighthawk #RM-676 you're also goin to need: - A baseplate kit, like the Roadmaster Direct-Connect Base Plate Kit #RM-521453-5. These attach to the Jeep itself so you…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Dimensions Of The Optronics 7-Pole Blade to 5-Pin Delphi Connector Strain Relief

Product Page this Question was Asked From

Continue Researching