Installation Process For A Dometic RV Water Heater
Updated 09/06/2024 | Published 09/01/2024
Question:
I bought a Salem cruise lite and the water heater was burnt up note: it was an all gas so I bought a Dometic hot water heater that’s both gas and electric but I have no clue how to install the on and off switch panels, and do I have to use a dometic switch board or can I use any?
asked by: Amethyst L
Expert Reply:
Hi Amethyst,
What is the model number of your new Dometic water heater? If you open the access door to the unit there should be a sticker either on the inside of the door or on the unit itself listing the model number. Once I know what you have I can walk you through the installation process.
Product Page this Question was Asked From
Single-Panel On/Off Switch for Atwood Gas and Electric Water Heaters - White
- Accessories and Parts
- RV Water Heater
- Switches
- White
- Atwood
more information >
Continue Researching
- Q&A: Replacement Water Heater Recommendation for Atwood G6A-7P
- Q&A: Troubleshooting Switch Not Staying in Position for Dometic Water Heater
- Q&A: Correct Replacement for an Atwood Water Heater GC6AA-9E
- Q&A: Recommended Replacement for Atwood G6A-7 Water Heater
- Article: Performance Chips and Modules
- Q&A: Is the Replacement Handle for Bladex and Valterra Waste Valves Threaded
- Q&A: Replacement Water Heater Gas Regulator for Atwood 91043
- Q&A: Replacement Standard tank Water Heater For an Atwood 6G Water Hearter
- Article: Trailer Wiring Diagrams
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box