Front Hitch that Fits 1993 Ford F-250 for Use with Plow
Updated 09/12/2024 | Published 09/01/2024
Question:
Will this work on a 93 f250 4x4 with a hiniker quick hitch snow plow?
asked by: Mike
0
Expert Reply:
Hey Mike, the Draw Tite front hitch part # 31310 is a confirmed fit for your 1993 Ford F-250 and can work with plows designed to fit in front hitches like the Hiniker Quick you mentioned.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 500 lbs Vert Load
- 5000 lbs GTW
- 9000 lbs Line Pull
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Tailgate Lock For 1989 Ford F-250
- Q&A: Recommended Thule Rail Kit for Leer Fiberglass Truck Bed Topper
- Q&A: How To Wire A 12V DC Tankless Water Heater In An RV That Previously Had A 120V Water Heater
- Q&A: Is Replacement Hardware for TorkLift Camper Tie Downs Available
- Q&A: Will Curt Adjustable Ball Mount Work with Bulldog Collar-Lok Coupler?
- Q&A: What are the Dimensions of TorkLift SuperHitch Original Trailer Hitch Receiver # TLF1000
- Q&A: Recommended Trailer Hitch With Extension For 1997 Ford F-250 With Camper And Boat Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
Mike
9/12/2024
The hiniker quick hitch does not utilize a front mount receiver hitch for mounting. It has its own frame mount. It looks like there might be room between the upper subframe of the plow mount and where the reciever hitch mounts. Whats the measurment from the center of the lower mounting hols to the bottom of the receiver tube? If I have that measurement i can measure to see if it will fit or not. If mot i may just weld a rec tube to the plow mount itself. That would definitely be stonger as it has many more frame mounting points than the receiver hitch.