Can 2023 Lance 1875 Camper with I Beam Bumper Use etrailer Cargo Carrier
Updated 01/27/2026 | Published 08/23/2024
Question:
I have a 2023 Lance 1875 with and I beam frame attached to my rear bumper. Will the support brackets on the 24x40 etrailer Cargo Carrier for RV Bumper - Steel - Folding - 500 lbs Part Number: e99050 attach to my I beams?
asked by: Dan
Expert Reply:
Hey Dan, so the etrailer bumper cargo carrier part # e99050 that you referenced is designed to attach to 4 inch or 4-1/2 inch square bumpers. If you have an I-beam crossmember that is 4 inch or 4-1/2 inch square I could see this working potentially but I would have to recommend you have it welded up so that it is boxed where you would want to attach this.
Product Page this Question was Asked From
24x40 etrailer Cargo Carrier for RV Bumper - Steel - Folding - 500 lbs
- RV Cargo Carrier
- Cargo Carrier
- Bumper Mount
- 500 lbs
- Folding
- 40 Inch Wide
- 24 Inch Deep
- Steel
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Could etrailer Folding RV Cargo Carrier be Used with 5 inch RV Bumper
- Article: Holiday 2025 | Best Gifts for Towers
- Article: Anti-Rattle Devices
- Q&A: Fitment of etrailer Cargo Carrier for RV Bumper on 2016 Nash 23D Travel Trailer
- Q&A: Compatibility of Resse Shank 54970 With Trunnion Bars 54946 and Hitch Head With Patent 5375867
- Q&A: Do I Need Full Rich Solar Kit If My RV Is Prewired With Solar On The Side Port?
- Q&A: What Is Included In Rich Solar Kits For RVs?
- Article: 4-Step Guide to Installing RV Solar Power
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Q&A: Will the Stromberg Locking Generator Box Fit on the Trailer Tray for A-Frame Trailers 240V Generator
- Q&A: Recommended Wireless Observation Cameras and Monitor for a Motorhome
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: What Do I Need To Tow A Trailer?
Jameson C.
1/27/2026
Hey Dan, did you end up trying the cargo carrier on your Lance’s I-beam frame after boxing it in as suggested? Knowing how that setup worked could help others with a similar bumper design.