Helper Springs for 2006 Chevrolet Silverado HD

Question

Question:

looking for spring for 2006 Silverado HD

asked by: Rodney M

0

Expert Reply:

Hi Rodney; I'm assuming you want helper springs like the Hellwig Load Pro 35 you were looking at. For your 2006 Silverado HD you will need the Hellwig Load Pro 35 Heavy Duty Helper Springs with Custom Mounting Kit # HE25XR. These fit the 1500 and 2500 HD models. They have a 3,500 lb capacity and come with a lifetime warranty.

expert reply by: Robin H

0

Answer 1

The Hellwig Contact Helper Spring #HE89SR sit on top of the overload springs on your 2024 GMC Sierra 3500 while the Hellwig Load Pro 35 Progressive Helper Springs #HE32XR basically reinvent the overload springs and do allow you to adjust how much…

view full answer...

Answer 2

I recommend going with the Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs #AL89DQ for hauling around an in-bed camper with your 2024 Ford F-350 Super Duty. I really like this kit because it has the higher 7,500 lb rating (which you don't…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Yes, we do have a set of air bags for your 2023 GMC Sierra 2500 with the factory towing prep package. They are the Air Lift LoadLifter 7500XL Air Helper Springs item #AL57541. These air bags have a 7,500 lbs capacity to keep the rear end of your…

view full answer...

Answer 6

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 7

So long as it is a Solera roller like item #LC33FR or item #LCV000211518 it will. The roller tubes are brand specific so if your tube isn't a Solera it won't be compatible with the Replacement Support Arms for Solera 12V XL Power RV Awnings…

view full answer...

Answer 8

Hi Donald, For a 150" flange to flange measurement you'll need the Solera RV Slide-Out Awning #LCV000163299. This slide topper is designed to fit 146" - 151" flange to flange measurements. Going a size larger than this could…

view full answer...

Answer 9

The 14-foot dimension shown for the Solera 12V XL Power RV Awning #LCV000334942-362241 refers to the outside to outside spacing of the two included 78-inch-tall wall-mount vertical brackets that contain the awning support arms. The fabric canopy…

view full answer...

Answer 10

Brien, it sounds like you did your research so kudos to you, but the awning you're looking at is not going to work with the wind sensor. You'd need to use the Solera Smart Arm 12V Power RV Awning #LC517517 instead. You're also going to…

view full answer...

Helper Springs for 2006 Chevrolet Silverado HD

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching