Voyager Wisight System that Can Replace Older System of 2016 Jayco Pinnacle 36FBTS

Question

Question:

I have a 2016 JAYCO Pinnacle 36FBTS. It has a Voyager WiSight Wireless Auto Paring WVCMS130AP camera with WVOS541 monitor currently installed. We have to replace the system as the camera has moisture in it causing the monitor to be cloudy and ASA stated it is not compatible with the current version. ASA recommended camera systems WVSXS70 ASA57YR or WVSXS43 ASA84YR. Do either one of these systems fit our JAYCO. Thank you for your assistance in this matter.

asked by: Dennis D

0

Expert Reply:

Hey Dennis, yes both of the systems you mentioned part # ASA84YR and # ASA57YR will work for your Jayco. The mounts are universal enough that won't be an issue and the wiring would be the same since you had a Voyager setup previous.

expert reply by: Jameson C

0

Answer 1

Hey Andy. To replace your AOM-713WP monitor you'll need the 7" Screen Voyager RV Backup Camera Monitor item #VOM719WP. You can connect the Voyager Rear Camera item #VCMS17B or the Passenger item #VCMS12RGPR and Driver item #VCMS12LGPR side…

view full answer...

Answer 2

Hello Alberta, thanks for reaching out. I have heard of this happening before with the Voyager monitors where condensation gets inside and fills the camera with water. Sadly there is not a great way to clean this and the camera is most likely done. I…

view full answer...

Answer 3

I have attached for you below the pairing procedure for the Voyager WiSight Wireless RV Backup Camera System part #ASA84YR. Please note, a mistake I have made in the past was applying power to the camera too soon, this cannot be done until the…

view full answer...

Answer 4

Hello Steven, thanks for reaching out and for your recent order. The Voyager WiSight 2.0 Wireless Backup Camera System #ASA24YR does not come with the camera pigtail for non-prewired RVs. For non-prewired RVs, you will need the following: - Voyager…

view full answer...

Answer 5

The mounting brackets between the WiSight 1.0 and the 2.0 like the part #ASA84YR are different so with this kit you would not be able to reuse them.

view full answer...

Answer 6

To see behind your 2018 Keystone Springdale18 foot travel trailer, I recommend the Rear View Safety Backup Camera System with Trailer Tow Quick Connect Kit #RVS-770613-213. Because it is a hardwired unit, the pairing and connection are not an issue.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Hey Bill, yes the Furrion Vision S+ #FR64AD would be a direct replacement for your current Vision S system. None of it is backwards compatible with the standard Vision S system though.

view full answer...

Answer 10

Hey Michael. The backup camera that comes with the Furrion Vision S+ System item #FR57AD has built in mounting holes in the casing. It comes with four #6 x 3/4" flat head self-tapping screws, four #4 x 1/4" self-tapping screws, sealant, and…

view full answer...

Answer 11

Thanks so much for the photo, it was super helpful, and what it shows is that your trailer has the Voyager WiSight Pre-Wire Plate. This will allow you to mount the Voyager WiSight camera system: - Voyager WiSight Wireless RV Backup Camera System…

view full answer...

Voyager Wisight System that Can Replace Older System of 2016 Jayco Pinnacle 36FBTS

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching