Will The Optronics LED Trailer Clearance or Side Marker Light MCL55AB Operate On 6 Volts?
Updated 01/19/2026 | Published 08/13/2024 >
Question:
will these lights operate on 6 volts?
asked by: Fred T
0
Expert Reply:
Hello Fred. The Optronics LED Trailer Clearance or Side Marker Light # MCL55AB is made to work with 12v systems, so this will not operate on only 6 volts. If you have 6v batteries you would need to wire two of them in series in order to power a 12v light.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Optronics LED Trailer Clearance or Side Marker Light - Submersible - 3 Diodes - Round - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 2 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How is Horse Trailer Side Pad # HTP60BK Usually Attached
- Q&A: Recommended AC System to Replace Two Dometic Duo-Therm AC Units Controlled by the Same Thermostat
- Q&A: Recommended Top Wind Swivel Jack that Fits a 2-1/2" Diameter Snap Ring Mount
- Article: Trailer Lighting Requirements
- Q&A: How Does X LED Truck and Trailer Tail Light part # BUL602CRB Get Wired Up
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Is Kenda Karrier KR35 ST205/75R15 Load Range C Or D
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Firestone Air Bags for 2026 Ford F-350 FX4 Dually
- Q&A: Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Finding the Right Electric Winch


Jesse M.
1/19/2026
Hey Fred, were you able to get your lights running after wiring your 6-volt batteries in series for a 12-volt setup? Knowing how that worked could help others trying to power similar trailer lights.