What Kind Of Rubber Is The Dutton-Lainson Boat Trailer Guide-On Roller DL21556 Made Of?
Updated 08/13/2024 | Published 08/08/2024 >
Question:
Hi Im interested in Boat Trailer Guide-On Roller, 2 Diameter x 9 Long by Dutton-Lainson and was wondering what middle of the roller has as core to keep it from collapsing on itself
asked by: John
Expert Reply:
Hello John. The Boat Trailer Guide-On Roller, 2" Diameter x 9" Long by Dutton-Lainson # DL21556 is made from a high strength marine grade rubber. The entire roller is one solid piece of material, and the core is made of the same rubber as the rest of it. I cannot say I have ever heard a complaint of the roller collapsing on itself, so they are quite sturdy.
Product Page this Question was Asked From
Boat Trailer Guide-On Roller, 2" Diameter x 9" Long by Dutton-Lainson
- Boat Trailer Parts
- Rollers
- Side Guide Roller
- 2 Inch Diameter
- Rubber
- 9 Inch Long
- Fits 1/2 Inch Shaft
- Dutton-Lainson
more information >
Continue Researching
- Article: Boat Trailer Guides: Which are the Best?
- Q&A: How Much Roller Shaft Length will Yates Endcap for Side Guide Rollers # YR224-4 End Up Taking up
- Q&A: How to Pick Out Trailer Hubs for Older Dilly Trailer
- Q&A: How to Remove Cap Nut on Roller Shaft
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: Do You Have Roll-Style Guide-On without the L Brackets for the Frame?
- Q&A: How to Cut Dutton-Lainson Boat Trailer Guide-On Roller # DL21554 Down to 8 Inches
- Q&A: How Much Can CE Smith Roller-Style Guide-Ons be Adjusted?
- Q&A: What Does Yellow Wire of 7-Way Molded Trailer Wire Connector H20044 Wire To
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision


John
8/12/2024
Hi thank you for your reply. I wanted to use them as bottom rollers for a 10'x20' flat bottom dock that I'm making into a boat. So all weight will be on the roller whole boat will be roughly 3000lbs. I would be using multiple rollers to distribute the weight but all weight will be on the rollers. Do you think these rollers would be able to handle that? The keel rollers I have been looking at are steel sleeved inside but they are tapered. I wanted the same durability with a flat roller. Is that possible? And actually I wanted the 2.5" rollers with the 5/8" shaft