Replacement Coupler for a 1992 Coleman Destiny Royale Trailer
Updated 01/19/2026 | Published 08/07/2024
Question:
Looking to replace a worn 1992 Coleman Destiny Royale trailer coupler with a new weld-on coupler for a trailer that weighs only about 12-1400 pounds.
asked by: Jerry H
Expert Reply:
No sure what size coupler you have on your 1992 Coleman Destiny Royale trailer, but I can give you the dimensions of the item # CA-5210-B you were looking at to make sure it fits.
I went out to the warehouse and measured the A-Frame Trailer Coupler item # CA-5210-B and the inside width of it measures 8-3/4". You'll want to make sure the spot on your tongue where the coupler installs is 8-3/4" for this one to work. If it's a bit less you can shim it but we'll need to go another direction if yours is larger. If it is larger go ahead and comment below with the measurement you do get and I'll be happy to find the right replacement.
As far as capacity and compatibility goes you should be set, the weld on A-Frame Trailer Coupler item # CA-5210-B has a 8,000 lbs capacity and fits a 2" hitch ball.
Product Page this Question was Asked From
A-Frame Trailer Coupler - Yoke Latch - Black - 2" Ball - Weld On - 8,000 lbs
- A-Frame Trailer Coupler
- Standard Coupler
- 50-Degree Frame
- Weld-On
- 8000 lbs GTW
- 2 Inch Ball Coupler
- Yoke Latch
- 2-1/4 Inch Hole
- Standard Grade
- etrailer
more information >
Continue Researching
- Q&A: Is There A Replacement Latch Kit Or Coupler For Older Atwood Coupler 88555 Flip Latch ?
- Q&A: Replacement Gear Kit Instructions and Diagram for Ram 12,000 Series
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Q&A: Looking For Brake Assemblies And Hubs For Dexter 4,400 lb EZ-Lube Axles
- Q&A: Solution for A-Frame Trailer Coupler Yoke Latch Repair Kit
- Q&A: How To Find Correct Replacement Electric Braking Assembly Parts for a Trailer
- Q&A: Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery
- Article: Most Popular Wheel Bearings
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Types of Trailer Hitches: How and Why to Use Each
Jerred H.
1/19/2026
Hey, did the 8-3/4 inch width on the A-Frame trailer coupler match the tongue on your Coleman Destiny Royale? Once you confirmed that fit, were you able to move forward with the replacement? Your update could make it easier for others working on older Coleman trailers.