Recommended Replacement Handle Bushing for a RAM 8k Trailer Jack
Updated 08/07/2024 | Published 08/02/2024
Products Featured in This Question
Question:
Where do I find a replacement bushing and washer for the shaft that goes above the bearing.
asked by: Jason
0
Expert Reply:
Hey Jason, it sounds like you're looking for the Replacement Sidewind Handle Shaft Bushing for etrailer and Ram Square, Direct Weld Jacks # TJD-7000S-BU.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-7/8" Lift - 7,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Standard Grade
- 6001 - 7000 lbs
- Manual Jack
- 28-7/8 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: Replacement Side Wind Jack Handle for 7000-lbs Square Direct Weld Jack
- Q&A: Disc Brake Conversion Kit for a 5th Wheel Trailer w/ 7,000 lbs Axles
- Article: Trailer Maintenance Schedule
- Q&A: Furrion Chill Cube AC Unit With Gasket, Distribution Box And Thermostat
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Hub and Rotor Replacement Kit for ALKO 12k Axles
- Q&A: Replacement U-Bolt Kit, Leaf Springs, Bolts and Shackles for 68 Aristocrat Lo Liner Trailer
- Q&A: Recommendation for Weld-On Rear Jacks for 2020 Griffin 7 Ton Dump Trailer
- Q&A: How Does Square Direct Weld Jack w/ Footplate Weld On to Trailer
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Gooseneck to 5th Wheel Adapters
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Wiring Diagrams
Jason
8/6/2024
No I am looking for the bushing that goes under the gear that is on the jack screw.