Where is Connector to Install the Curt Wiring Harness part # C55365 on a 1999 Toyota Land Cruiser
Updated 05/13/2014 | Published 05/12/2014
Question:
I cannot find a connector to plug into on my 1999 landcruiser. There is a wiring harness already there but it seems to run up the truck towards the drivers side tail light but It seems to have no power. Any ideas on how to install the new part?
asked by: Ralph W
Expert Reply:
To locate the factory connector on your 1999 Toyota Land Cruiser to Install the Curt Wiring Harness part # C55365 you will need to first lower the spare tire to gain access to the vehicle's tow harness plug, locate the vehicle's rear passenger side trailer connection, remove the cap and tape, plug the # C55365 into this connector.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: 18144
- Shop: Trailer Wiring
- Q&A: Installing Trailer Wiring Harness on 2000 Toyota Land Cruiser
- Q&A: Recommended Trailer Hitch Receiver and Wiring for 2022 Toyota Highlander XSE Without Tow Package
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Towing Package for a 1999 Toyota Land Cruiser
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: 4-Way Wiring Harness for 2025 Hyundai Santa Fe HTRAC AWD
- Q&A: Best Hitch for a 2022 Toyota Highlander
- Q&A: Trailer Hitch For 2007 Toyota Camry LE With Dual Exhaust
- Q&A: Recommended Trailer Wiring Harness for a 2007 Toyota Camry XLE
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)