Has Mounting Holes for Lippert Replacement Screen Door Latches Changed
Updated 02/03/2026 | Published 07/11/2024
Products Featured in This Question
Question:
Your dimensions are exactly what I need, but the lippert latch has the mounting holes offset - not centered like the one you have dimensioned. What is the part number on the one you have dimensioned? My current mounting holes are 3” on vertical center and 9/16” from edge to the mounting hole.
asked by: Larry
Expert Reply:
Hey Larry, thanks for reaching out!
The photo you're referring to of the Lippert screen door latch is an older photo and it looks like Lippert has since then changed the designed for the holes to be offset. If you check out the Left Swinging # LC201472 and Right Swinging # LC201471 handles you'll see what I'm talking about.
(click to enlarge)
Product Page this Question was Asked From
Replacement Screen Door Latch for Left Swinging RV Entry Doors
- RV Door Parts
- Screen Door
- Latches
- Plastic
- Black
- Lippert
more information >
Continue Researching
- Q&A: Outlets In Jayco Camper Work But Batteries Aren't Charging. Does It Need New Distribution Panel?
- Q&A: Looking for Replacement Converter Panel for 2005 Gulf Shore Cavalier
- Q&A: Step Covers for Suburban 3-Step Entry Steps
- Q&A: Availability of Timbren Rear Suspension Kit that Fits 2026 Toyota Tundra
- Q&A: Replacement Screen Door Latch for Phillips Doors Dimensions
- Q&A: Replacement Breakaway System for Brake Buddy Vantage 39504
- Q&A: Vacuum Line Fitting Needed To Install The Demco Stay-In-Play In A 2020 Ford F-150
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Measure for Trailer Hitch Drop
- Article: How Much Solar Power Do I Need For My RV?
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
Samuel C.
2/3/2026
Hey Larry, did the updated Lippert screen door latch with the offset holes line up with your mounting points? Knowing how that fit worked out could help others trying to match the same latch style.