Troubleshooting MaxxAir 7000K Not Operating Properly With New Lift Motor and Circuit Board
Updated 02/03/2026 | Published 07/01/2024 >
Products Featured in This Question
Question:
I have a replacement motor and circuit board for my maxxair 7000k. I’m replacing with the parts below but my fan will not work. It basically tries to close the lid and spins up the fan. Once the lid is closed it stops and won’t do anything else.
asked by: Ian
Expert Reply:
I do see the Lift Motor # MA10-20270 and Circuit Board # MA10A21275K are the correct units for your MaxxFan Deluxe Roof Vent # MA00-07000K. I would start by checking the wiring and voltage going to your vent fan and 90% of the time the issues with this vent has to do with either over or under voltage. You will want to use a Multimeter # PT89ZR to also test the voltage when operating the fan to determine if the voltage is dropping to much when the fan starts to turn.
Product Page this Question was Asked From
Replacement Printed Circuit Board for MaxxAir Powered Lift RV Roof Vents w/ Reversible Fan
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Circuit Board
- MAXXAIR
more information >
Continue Researching
- Q&A: Looking For A Replacement Circuit Board For My MaxxAir Fan Part 10B24275N
- Q&A: Replacement Circuit Board for a 4700 Model MaxxAir Roof Vent
- Q&A: Replacement for Lippert 289252D Leveling Control Module on a 2013 Winnebago Sunstar 35F
- Q&A: Looking for Replacement Control Module for Lippert Leveling System
- Q&A: Need Replacement For MaxxAir Circuit Board 10A21275N
- Q&A: Replacement Circuit Board for MaxxFan 8900N RV Fan
- Q&A: Troubleshooting MaxxFan 4700 Series, 4700K
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Install E-Track in 3 Easy Steps
- Article: Performance Chips and Modules
- Article: Best RV Roof Vents
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips



Jameson C.
2/3/2026
Hey, how did things go after you checked the wiring and voltage on your MaxxFan Deluxe vent? Were you able to get the fan running properly once you tested it with the multimeter? Your update could make it easier for the next person troubleshooting the same issue.