What Size Hole Saw for Installing Mighty Cord Replacement RV Power Inlet # A10-50INVP
Published 06/18/2024
Question:
This will be used on a conversion trailer. So there is no preexisting hole to install. What size hole saw would I use to create the mounting hole? Thank You
asked by: Wayne
0
Expert Reply:
Hey Wayne, the portion of the outlet part # A10-50INVP that you referenced that sticks through the wall of the trailer is 2-1/4 inch in diameter so I would go with just a little larger than that for an easier install like 2-5/16 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Mighty Cord Replacement RV Power Inlet - Twist Lock - 50 Amp - White
- RV Power Inlets
- Power Inlets
- 50 Amp
- Plastic
- Twist Lock Connector
- White
- Mighty Cord
more information >
Continue Researching
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Replacement Transfer Switch
- Q&A: Will MouseBlocker 360x Affect Dogs
- Q&A: Replacing Power Center and Distribution Panel
- Q&A: Should a 1000 or a 360 MouseBlocker Rodent Deterrent be Used for Inside a Travel Trailer?
- Q&A: Do I Need Special Fuses Or Breakers When Installing New PowerMax Power Center Converter In RV?
- Q&A: What All Is Involved When Replacing WFCO WF-8955-AD Power Center Converter In RV ?
- Q&A: Is Weight Distribution Needed for 2019 Chevy Silverado 1500 Towing 2019 Keystone Hideout 22RBWE
- Article: Thank you!
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Steel vs. Aluminum Ball Mounts
- Article: Trailer Lighting Requirements
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
Wayne
6/18/2024
Thank you sir