Will Coil SumoSprings Custom Helper Springs Fit 2024 Kia Telluride S FWD

Question

Question:

I have a front wheel drive 2024 Kia Telluride S. Are these appropriate / fit for front wheel drive Tellurides? Need to help prevent real squat when loaded with platform bike rack, roof box, three adults, and two large dogs.

asked by: Brett

0

Expert Reply:

The # CSS-1125R are only confirmed to fit 4WD models of the 2024 Kia Telluride. There is probably a Coil SumoSpring kit that will work but you will need to measure to find out which one.

Measure the gap between in the middle of the coil with your vehicle sitting on the ground. You also want to make sure it is sitting level so each side of the vehicle should be within 1/4" when measured. I have attached a picture below showing where to measure. If you can send me this measurement I can find out which one is the correct fit.

expert reply by: Robin H

0

Coil SumoSpring Measurement
(click to enlarge)

Answer 1

All 3 options are the same Coil SumoSprings: #CSS-1168 #CSS-1168R #CSS-1168F The difference in the part numbers just has to do with R is for rear, F is for front and then we have the regular number in case someone is looking for the part to fit a…

view full answer...

Answer 2

They sure are Charlie and welcome back! The biggest inconvenience you're going to run into removing and reinstalling the Coil SumoSprings item #CSS-1125R are jacking up the rear end of your Subaru each time and removing the rear wheels. You will…

view full answer...

Answer 3

The SuperSprings Coil Spring Inserts, #CSS-1125 and #CSS-1125R, are the same exact part and both will fit your 2011 Honda CR-V EX-L. The actual part number from SuperSprings is CSS-1125, but we put an R or an F on the end of the part numbers for…

view full answer...

Answer 4

Hello again Jerry! The Timbren SES Coil Spring Suspension #T72AV uses a grommet and snap rings to secure it. See the attached photo. This is a cleaner install when compared to the SumoSprings #CSS-1125R, at least assuming you choose to use the zip…

view full answer...

Answer 5

Congrats on the new motorhome Gary! The SumoSprings Solo Custom Helper Springs item #SSF-106-47 are going to be the correct ones for your 2026 Thor Vegas on Ford E450 chassis. These have a 1,000 lbs capacity and will really help with bumps and that…

view full answer...

Answer 6

Hey James! For a 2020 RAV4 I'm not entirely sure if that is too much or not. Does it feel like your braking is off when you carry everything? Are the headlights tilting up from the rear sag? Are you bottoming out? If any of these things are true…

view full answer...

Answer 7

Hey Jennings! We don’t currently carry any 2-way propane/AC combo models like your old Norcold, so if you want to go that route you will have to look around elsewhere and match up whatever you find to your existing cutout. For a 12V I recommend one…

view full answer...

Answer 8

Hi Norma; if there is nothing on any of the stickers the best you can do is look and see what currently fits. I don't believe they ever updated the hitch for the 2017 so assuming it has a 2" receiver it would be the #C13135. Were you…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

Hi Steve! There are two options that will help the sag you are getting in your 2021 Honda Pilot when you are towing. The first is the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension #CSS-1125F. We have these listed as being for the…

view full answer...

Will Coil SumoSprings Custom Helper Springs Fit 2024 Kia Telluride S FWD

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching