What is Replacement Lid Lifter For Thule Force XT Rooftop Cargo Box

Question

Question:

Hello I own the Thule Force XT XL and the rear load lifter is broken. I found that the load lifter part is item 1500056463. Do you sell this part number? I am not sure I found the exact match on the website.

asked by: Lawrence

0

Expert Reply:

Hey Lawrence,

We do sell the replacement lid lifter for your Thule Force XT rooftop cargo box. You do have the right part number, but we have it listed as a different number for our website. But I verified 100% this is the right replacement part for your Force XT:

- Replacement Lid Lifter # 1401495600

expert reply by: Kyle S

0

Answer 1

Thanks for the picture! Yes, there is a way to get around this horrible design and replace the hinge on your Motion XT XXL. Thule is less than helpful with directions on their replacement parts but we have encountered this issue before. To install…

view full answer...

Answer 2

The #TH14936 isn't a fit for the Thule Motion XT-XXL. You'll want to use #1401495600, as confirmed by Thule.

view full answer...

Answer 3

I confirmed with Thule that the correct replacement lid lifter hinge for your Thule Motion XT XXL Rooftop Cargo Box #TH629906 is #1401495600. I went ahead and attached a photo to show where this hinge is located on the cargo box so you can verify…

view full answer...

Answer 4

According to Thule, the proper replacement lid lifter for the Thule Motion XXL cargo box is their part number 1500056463 which we carry as part #1401495600. Just to be sure, I've confirmed this with my Thule representative.

view full answer...

Answer 5

The replacement hinges for your Thule Force XT XL Rooftop Cargo Box #TH6358B unfortunately are no longer available. You might be able to find them through some place like a marketplace, but aside from that you'll need to replace your box. For a…

view full answer...

Answer 6

The Lid Lifter Hinge #1401495600 is the correct part for the Thule Motion XT XL Cargo Boxes #TH629806 & #TH629807.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

What is Replacement Lid Lifter For Thule Force XT Rooftop Cargo Box

Continue Researching