Application Of The Ultra-Fab Steel Roller for RVs with 2" Trailer Hitches # UF48-979020
Updated 05/13/2024 | Published 05/10/2024
Products Featured in This Question
Question:
Can this be used on a down trailer hitch, not the receiver. I have a Blue Ox and the lower part of hitch drags going back in driveway. Thanks. Frank
asked by: Frank
Expert Reply:
Hi Frank,
Are you saying you want to use the Ultra-Fab Steel Roller for RVs with 2" Trailer Hitches # UF48-979020 on a Blue Ox ball mount with a drop or an adapter kind of like the # BX88132? It would work with the # BX88132, but if you want to send me some pictures of where you're wanting to connect it I can confirm whether this would be the right fit or not. This specific roller is designed to fit 2" receiver tubes and be secured in place with a hitch pin and clip.
Product Page this Question was Asked From
Ultra-Fab Steel Roller for RVs with 2" Trailer Hitches
- RV Skid Wheels
- Hitch Mount
- Bolt-On
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Height That Side Mount Roller Lifts Off Floor
- Q&A: How to Tell If Spare Tire Carrier Will Work with Yakima BackRoad Bike Rack on a 2019 Lexus NX 300h
- Q&A: Roadmaster Rollaway Trailer Hitch Protector With Hitch That Has Chain Tabs Below Receiver
- Q&A: How To Find the Correct Skids Wheels for an RV
- Q&A: How to Prevent the Trailer Hitch from Scraping the Ground on a 2015 Subaru Legacy
- Q&A: How Close to Vehicle Tongue Weight Capacity Can You Go
- Q&A: Spare Tire Cover for 295/70R17
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Flat Towing Package for 2008-2011 Honda CR-V
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Converting Your RV Water Heater to Tankless