Can Slide Be Out When Replacing Motor and How to Test Slide Out Motor
Updated 04/16/2024 | Published 04/15/2024
Question:
This motor aligns exactly with the part number on the motor that failed in my 2016 Jayco X213. When replacing this part can the slide be out? This motor slides a king size bed slide out the back of the RV. Also, is there a way using a multimeter to test the existing motor to make sure it is the problem?
asked by: Tom
Expert Reply:
Hey Tom, thanks for reaching out!
Yes, your slide can be out when you're replacing the motor.
To test your current motor you'll just need to swap the polarity to see if it runs. If it doesn't run then you need the Replacement Motor # LC125802 (make sure that 18:1 gear ratio is correct though if your slide uses 2 motors), but if it does run then that means you have bad wiring somewhere that needs to be fixed.
Product Page this Question was Asked From
Replacement 18:1 Tuson Motor for Lippert Through-Frame Slide-outs
- RV Slide Out Parts
- Motor Parts
- Motor
- Lippert Through-Frame Slide-Out Systems
- Lippert
more information >
Continue Researching
- Shop: Replacement 18:1 Tuson Motor for Lippert Through-Frame Slide-outs
- Q&A: Replacement Slide-Out Motor for Model 1-065-041-012 Slide-Out on 2014 Forest River Rockwood
- Q&A: Replacement Slide Out Motor and Gearbox for Thompson 7828696
- Q&A: Replacement for Lippert Slide Out Motor 131903
- Q&A: Lippert Slide Actuator and Motor Assembly Replacement Lippert P/N 1A 041012-24-01
- Q&A: Replacement Motor for Slide Out Motor with Part # 8532-18HT
- Q&A: Replacement Motor and Actuator Recommendation for Lippert 9,000 RPM Setup
- Q&A: Replacement for Lippert Slide-Out Motor on 2016 Grand Design Reflection 337RLS
- Article: How Much Solar Power Do I Need For My RV?
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Can You Flat Tow a Subaru Crosstrek?
- Article: Trailer Maintenance Schedule
- Article: How to Replace a Rubber RV Roof
- Article: How to Replace or Install an RV Roof Vent
Tom
4/15/2024
Is the set screw on the top of the motor included? Also, I am getting conflicting information about the set screw. Can you verify if the hole is threaded or does it require a tap to thread the whole and a separate set screw? If so what size tap, how many threads per inch and how long should the screw be?