Does Lippert Tread Lite Step part # LC353543 Come with Everything Needed to Install

Question

Question:

Is this just the steps themselves or does this include the motor, gearbox and control module?

asked by: Chynna

0

Expert Reply:

Hey Chynna, the Lippert Tread Lite steps part # LC353543 that you referenced is a complete step kit. It includes the motor, gear box, control module etc. Basically it comes with everything needed to complete the install.

expert reply by: Jameson C

0

Answer 1

The Replacement Control Module for Lippert Electric Coach Step #LC301702 is the correct fit for your Lippert Coach step. The long green wire with the ring terminal is your ground and will be attached bare metal to metal on our coach frame. The short…

view full answer...

Answer 2

If you check out the diagram I attached you will see how the steps should get wired up. What I would first do is verify that you have voltage in all of the right places on your steps to determine if the module needs to be replaced with the #LC301702.…

view full answer...

Answer 3

For a double step that is 24 inches wide and is a manual pull out step we have the part #SMFP-2100 which is pretty similar to the #LC353543 without the motor.

view full answer...

Answer 4

While we don't have an install video for the specific Tread Lite step you mentioned part #LC353543 I did attach an install video for a similar Lippert Kwikee step that will show you the basics of a step install for you to check out.

view full answer...

Answer 5

The fuse for power steps on a motorhome, like part #LC3658373, will be found on the 12V power wire that runs to your battery bank as opposed to a fuse in the power center like what you find on a vehicle. What you're looking for is a fuse holder…

view full answer...

Answer 6

Hey Ron! We have quite a few replacement options for RV steps and step components. If you could comment below with a part number off of yours I would be happy to check out what options we have. If you can't find a part number the manufacturer and…

view full answer...

Answer 7

We do have a wiring diagram for the Lippert Components Kwikee Step Rocker Switch #LC371010. I have attached a clip from the installation instructions that demonstrates how to wire this for you to check out.

view full answer...

Answer 8

If you were to install the Lippert Components Kwikee 25 Series Triple Electric Step part #LC3658373 using only an on/off switch then you could wire this directly to the battery using the attached diagram. The control unit would not be used for this…

view full answer...

Answer 9

To bench test the Motor #LC183058 on your Lippert Electric Tread Lite Step #LC353620 you can simply connect the motor wires a 12 volt battery source to operate the motor. The motor is reverse polarity so you can run it in and out by alternating the…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Does Lippert Tread Lite Step part # LC353543 Come with Everything Needed to Install

Product Page this Question was Asked From

Continue Researching