Can Malone Channel Loader Kayak Load Assist # MAL48FR Work with Oldtown PDL 106
Updated 04/03/2024 | Published 04/02/2024 >
Question:
I have an Oldtown PDL 106 and a 2024 Subaru Outback. Will this work to help me get my kayak on the roof? I see it works for the Outback and want to make sure it is strong enough for this kayak. Thanks!
asked by: Bryan
0
Expert Reply:
Hey Bryan, the Malone Channel Loader Kayak Load Assist # MAL48FR has a 75 lb weight capacity and I did my best to look up the weight of your Oldtown PDL 106 and found it looks to weigh right around that but maybe a little less/more. But either way it's not going to fully support the weight of the kayak at any point so it will work just fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Malone Channel Loader Kayak Load Assist
- Accessories and Parts
- Watersport Carriers
- Load Assists
- Kayaks
- Malone
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can I Use the Swagman Exo Aero Kayak Carrier with the Stinger Load Assist for Malone SeaWing?
- Q&A: Comparing Yakima LowRider Kayak Trailer to Malone EcoLight Sport Trailer
- Q&A: Recommended Roof Rack for a 2013 Mazda 3 w/ Anchor Points on the Roof
- Q&A: Height of Malone Channel Loader Kayak Load Assist MAL48FR
- Q&A: Why Should Rubber Strip Be Installed With TracVan on 2008 Ford E-150 Van
- Q&A: Difference Between Yakima CoreBar and JetStream Roof Rack Crossbars
- Q&A: Yakima Flush Mount Roof Rack For 2022 Honda Pilot With Flush Side Rails
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Article: Rooftop Cargo Carriers
- Article: How to Strap a Kayak to a Roof Rack in 4 Steps (With Pictures)
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Determining Trailer Tongue Weight
- Article: Trailer Hitch Receiver Sizes


Bryan
4/3/2024
Hello. Thanks for responding. Your answer says it will not fully support the weight of the kayak at any point so it will work just fine. Can this be clarified? Sounds like it won’t support the weight but yet it will work? Thanks for the information.