What Holds The LED Step and Accent Light # TN92VR In Place?
Published 02/06/2024
Products Featured in This Question
Question:
watched video on lights but not sure what holds light tight on side of rv
asked by: Rick J
0
Expert Reply:
The LED Step and Accent Light # TN92VR is designed to fit a 3/4" hole with the included grommet. The grommet will fit into the hole and then the light pushes into the grommet. With the light in place it prevents the rubber grommet from sliding out. I have included another video near the bottom of the page showing the installation for a similar Light # MCL10AKB on a utility trailer.
expert reply by:
Bud M
0
Product Page this Question was Asked From
LED Step and Accent Light - Recessed Mount - 1 Diode - Black Cover - White LED - Clear Lens
- Boat Lights
- Accent Lights
- Cabinets
- Countertops
- Steps
- Walkway
- Black Housing
- Recessed Mount
- LED Light
- White
- TecNiq
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: LED Step and Accent Light - Recessed Mount - 1 Diode - Black Cover - White LED - Clear Lens
- Shop: LED Step and Accent Light - Recessed Mount - 1 Diode - Chrome Cover - White LED - Clear Lens
- Q&A: Which is Better for Highway Use 4.80-12 or 5.30-12 Trailer TIres
- Q&A: Recommended Replacement for Dometic WH-6GA RV Water Heater
- Q&A: Replacement Option for a Rola Vortex Cargo Basket
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Q&A: What is the Correct Replacement Converter for Parrallax 7300 Model 7355 Converter
- Q&A: Replacement Roof Vent Cover For A Maxxair 4700G
- Q&A: What Wet Bolt Kits Work With Road Armor Equalizers LC696740
- Q&A: Should I Use 2-1/4 or 3-1/8 Shackles with the Road Armor Shock Absorbing Equalizer Kit
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: How to Install an RV Awning From Scratch