How Many Mounting Holes Does Hitch for 2000 Nissan Xterra Use
Updated 02/05/2024 | Published 02/04/2024
Question:
The hitch for 2000 Nissan Xterra says fits but my Xterra does not have 3 holes per side but only 2. At end where the 3rd hole should be at rear close to the rear bumper is a one and quarter inch diameter hole that had been stamped out when made. Should I attach the hitch using only four bolts? Would that be safe?
asked by: Brian Z
Expert Reply:
Is it possible that the third hole isn't visible on your 2000 Nissan Xterra right now but it's there? We don't have a different hitch that uses a different mounting setup though so I would be surprised if you didn't have the three holes.
Product Page this Question was Asked From
etrailer Rubber Hitch Cover for 2" Trailer Hitches - Qty 1
- Hitch Covers
- Misc Covers
- Plain
- Rubber
- Fits 2 Inch Hitch
- Standard
- Square
- etrailer
more information >
Continue Researching
- Q&A: Stealth Hitch that Fits 2024 Ford Mustang Mach-E
- Q&A: Best Replacement For Older Dometic Duo Therm 57915.531 Ducted Single Zone AC System With Furnace
- Q&A: Does Roadmaster Invisibrake System Require Installing Diodes too
- Q&A: Replacement Air Conditioner for a Dometic Duo Therm 600315.331
- Q&A: Recommended Replacement AC for a Dometic 57915541
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Air Conditioner 13,500 BTU Will Replace My Current Dometic Air Conditioner?
- Q&A: Replacement AC Unit for a Dometic B59516
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Trailer Wiring Diagrams
- Article: Best Bike Racks for Electric Bikes