Replacement Spring Pin for Yakima DoubleDown Bike Rack

Question

Question:

Hi, I need a replacement for the locking mast on a Yakima doubledown ace 5 bike rack. The whole mast mechanism came off while I was driving and I lost it. It is the big locking bolt that you pull up to allow the bike rack to tilt away from the towbar so you can open the boot. Thanks for help

asked by: Simon T

0

Expert Reply:

That's not good! It sounds like it come unthreaded. To replace it you will need the Replacement Spring Pin for Yakima DoubleDown or DoubleDown Ace Bike Racks item # Y90175. This is the pin that allows the bike rack to tilt down so you can access the rear of your vehicle.

expert reply by: Jerred H

0

Answer 1

Most Yakima hanging racks like your RidgeBack use the same hitch pin. The pin you're looking for is part #889-0231.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Hey Greg, welcome back! The Go Power Overlander Expansion Kit - 200 Watt Solar Panel item #34282182 includes the Overlander panel. It's a bit different than your current Go Power GP-PV-200M panel, however it is compatible. The solar panel…

view full answer...

Replacement Spring Pin for Yakima DoubleDown Bike Rack

Continue Researching