Does Valterra Wheel Chock Have a Weight Capacity

Question

Question:

Does this have a weight capacity?

asked by: Bev

0

Expert Reply:

The Valterra Wheel Chock # A10-0908 doesn't have a weight capacity since it isn't really designed to hold the weight of a vehicle - it's just meant to keep a wheel from rolling.

expert reply by: Jon G

0

Answer 1

Utilizing wheel chocks like the Anderson Tuff Chock #3605 wouldn't be ideal for the angle you are stating. Of course the weight of the boat is likely not distributed evenly over the axle, there are some chocks I believe would work for the…

view full answer...

Answer 2

The best way to power the interior lights in your trailer is with its own independent battery. You will not want to use the breakaway battery. The breakaway battery is only designed to operate the breakaway and will drain extremely quickly,…

view full answer...

Answer 3

Good morning Hurley (cool name by the way. I like the clothing brand Hurley). Also, congrats on the new-to-you Chevy! That is an excellent question that comes up from time to time on various vehicles and weight distribution systems. So on your 2023…

view full answer...

Answer 4

Hello Jacob, thanks for reaching out. There are a lot of different locks that can work with the Demco Ez-latch coupler. To be honest, any lock can be defeated, it is just a matter of how difficult the lock would be to defeat. A really good all-around…

view full answer...

Answer 5

Sam, the Air 2D #AU56MR heater is ideal for smaller vans, campers, and boats. It draws less fuel and power. But if your van is larger, or you’re heating multiple areas, the 4D #AU96MR heater gives you more airflow and faster warm-up. It also cycles…

view full answer...

Answer 6

Hi Kipp; the Blue Ox SwayPro Weight Distribution w/ Sway Control for 2-1/2" Hitch #BLU54TR will work well with this setup. The tongue weight range for this system is 1,000-1,500 lbs. With batteries and propane added to the trailer tongue you…

view full answer...

Answer 7

Thats a good question Tabitha, and thanks for reaching out. The most common size for a grease fitting or zerk fitting is the standard 6 mm x 1.00. The only way to truly know what size you will need would be to measure one, and with yours missing that…

view full answer...

Answer 8

To unhook the Blue Ox TrackPro Weight Distribution w/ Sway Control - 7-Hole Shank - 10K GTW, 1K TW #BLU77FR when you are done towing you will need to jack up the trailer to take some tension off the spring bars, and then as you mentioned remove the…

view full answer...

Answer 9

Most trailer jacks like the Lippert #LC285318 only use one wire. That wire provides the power and the assembly grounds through the mounting hardware of the jack. It's hard to tell what's going on with the electric tape and splice connector I…

view full answer...

Does Valterra Wheel Chock Have a Weight Capacity

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching