Does The Pin Assembly On The Pollak 6-Pole Socket PK11609 Push Out The Front Or Back
Updated 10/30/2023 | Published 10/27/2023
Products Featured in This Question
Question:
Is the pin assembly of the 6-pin socket pushed out of the front or pulled out of the rear? I want to add a wire.
asked by: Phill F
0
Expert Reply:
The pin assembly on the Pollak 6-Pole Socket # PK11609 will push out the front of the socket. I have linked one of our install videos below. If you fast forward to about the 2:30 mark you can see the installer disassemble to socket.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Pollak 6-Pole, Round Pin, Trailer Wiring Socket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 6 Round
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Replacement Bullseye Monitor for Curt RVibrake Braking Systems Work with Serial Number 44k
- Q&A: How Does Replacement Command Center Tablet for Curt RVibrake 3 Charge
- Q&A: Replacement Brake-Away Kit For Brake Buddy Braking Systems
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Is Battery Disconnect Required When Flat Towing A 2019 Chevy Suburban?
- Q&A: Demco Air Force One Braking System For Factory Prepped Tiffin RV
- Q&A: Do Curt Single Hook Coiled Safety Cables Meet Legal Requirements for Towing
- Article: What Is Flat Towing and How to Ditch the Trailer
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2008-2011 Honda CR-V
- Article: Tow Bar Wiring: Which Wiring Kit is for You?