Required Hole Size for Installing the LED Mini Side Marker and Clearance Light
Published 10/25/2023
Question:
What size hole is needed for this light?
asked by: John D
0
Expert Reply:
You can use a drill with a 23/64 drill bit to make a hole for installing the LED Mini Side Marker and Clearance Light # MCL290RPG on your trailer. We had a customer successfully do this and they said the rings on the grommet along with the sticky back were sufficient for keeping the light in place on their trailer.
expert reply by:
Jon G
0
Product Page this Question was Asked From
LED Mini Side Marker and Clearance Light - Submersible - Bullet Connectors - Adhesive Mount - Red
- Trailer Lights
- Clearance Lights
- Marker
- Oblong
- Surface Mount
- Submersible Lights
- LED Light
- 1-1/2L x 3/4W Inch
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Hub and Drum Assembly with 8 on 6-1/2 Bolt Pattern for Dexter 10,000 Pound Trailer Axle
- Article: Trailer Wiring Diagrams
- Q&A: Dexter Hub # 008-430-03 Replacement Wheel Studs
- Q&A: Total Added Clearance for HappiJack Camper Jacks on BIgfoot 2500
- Q&A: HappiJac Swing Out Bracket for my Dually.
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: Correct Replacement for Dexter 13-10 Equalizer
- Q&A: Replacement Horse Trailer Door Lock for 1998 Featherlite
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing
- Article: Snow Tire Chains Review
- Article: How to Wire an Electric Winch