How Wide Is The Center Hanger for 2-1/2" Slipper Springs # 10GDH-CTR
Published 10/04/2023
Products Featured in This Question
Question:
How wide is this hanger? My equalizer is 4” wide with a 4.5” wide center hanger.
asked by: James G
0
Expert Reply:
The spacing in the Center Hanger for 2-1/2" Slipper Springs # 10GDH-CTR is approximately 3-3/8" wide so it'll be a bit too small for your equalizer to fit. You might consider the Center Hanger for 2-1/2" Wide Slipper Springs # 092920 instead which has a 4-3/16" inside spacing. It is a bit shorter at 1-7/8" tall but is the only option we currently have available for a 2-1/2" slipper spring.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Center Hanger for 2-1/2" Slipper Springs - 4-3/8" Tall
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2-1/2 Inch
- 1 Inch Diameter
- 4-3/8 Inch Tall
- Tandem Axle
- Triple Axle
- Redline
more information >
Continue Researching
- Q&A: Electric Trailer Brakes Not Working After Replacing Magnets and Confirming Power to Magnets
- Q&A: Recommended Replacement Cylinder Kit for a Dexter Hydraulic Drum Brake Kit
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Electric Over Hydraulic Brakes Not Operating Correctly When Connected to a 2017 Ram 3500
- Q&A: What Does JJ Mean When Looking at Wheel Size on Trailer
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: How to Determine Correct Replacement Slipper Springs for Triple Axle Trailer With 8,000 lb Axles
- Q&A: Where Should a Slipper Spring Sit on the Hanger Bolt of My Suspension
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Can You Flat Tow a Jeep Compass?
- Article: How to Tell the Weight Rating of a Trailer Axle