What Size Thread Tap for Weld Nuts of 2006 Honda Ridgeline for Draw Tite Hitch
Published 09/13/2023
Question:
I recently bought a Draw-Tite hitch for my 2006 Honda Ridgeline. I need to clean out the factory nuts and want to use a hand tap and die set. What size tap should I use? Is it 1/2 TPI?
asked by: John C
1
Helpful Expert Reply:
The weld nuts in the frame of your 2006 Honda Ridgeline for the Draw Tite part # 75280 take an M12x1.25 size bolt so that would be the size thread tap.
expert reply by:
Jameson C
1
Continue Researching
- Shop: Trailer Hitch
- Shop: Replacement Hardware Kit for Trailer Hitches
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Hitch and Mounting Brackets for 2006 Honda Ridgeline
- Q&A: What Modifications Need to Made on 2012 Honda Ridgeline to Install a Curt Front Mount Trailer Hitch
- Q&A: Difference in Detail K2 Snowplow for 2" Hitches and the Detail K2 Elite Snowplow
- Q&A: Trailer Hitch Recommendation for 2006 Honda Ridgeline that is Rated for Weight Distribution
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Best Bike Racks for Electric Bikes
- Q&A: Recommended Snow Plow for 2019 Ford F-250
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Front Mount Hitch Recommendation for a 2013 Honda Pilot
- Q&A: Front Hitch Recommendation for 2005 Honda Pilot