Conventional Ramp Door Spring Mounting Bracket Dimensions
Updated 09/12/2023 | Published 09/10/2023
Question:
How deep are the mounting brackets? Thank you.
asked by: Stacy T
0
Expert Reply:
The mounting brackets for the Conventional Ramp Door Spring # M364FR are 6-1/4" deep and 4" wide.
expert reply by:
Scott S
0
Product Page this Question was Asked From
Conventional Ramp Door Spring for 6' Wide Enclosed Trailer - Single Spring - 80-lb Capacity
- Trailer Ramp Springs
- Single Ramp Spring
- Torsion Spring
- 150 Inch Cable
- 85 lbs or Less
- Conventional Spring
- 4 Foot Wide Trailer
- 5 Foot Wide Trailer
- 6 Foot Wide Trailer
- 66 Inch Wide Spring
- M-3 and Associates
more information >
Continue Researching
- Q&A: Choosing the Correct Replacement Spring for an Enclosed Trailer Ramp Door
- Q&A: What Comes Included With The Timbren Silent Ride Suspension for Tandem Axles TSR7000T04?
- Q&A: Can Cable be Ran on Top for the Conventional Ramp Door Spring?
- Q&A: Can The EZ Gate Tail Gate Lift Assist Be Used On a 6' X 12' Enclosed Trailer?
- Q&A: Servicing Electric Trailer Brakes on a Tandem Axle Trailer with 10,000 Pound Axles
- Q&A: Will Redline Grease Seal # 1105-100-031 Replace Hadco 3122 Grease Seal
- Q&A: How to Pick Out Replacement Grease Seals for Hadco 3122
- Article: Trailer Lighting Requirements
- Article: Anti-Rattle Devices
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Install E-Track in 3 Easy Steps
- Article: Must-Have Flat Towing Components