Can CE Smith Narrow V-Wing Bolster Bracket be Shifted

Question

Question:

Can these be shifted completely to one side when mounted, so that the frame is not centered underneath it, or are they slotted only to allow mounting different width u bolts?

asked by: Tony

0

Expert Reply:

Yes, if you'd like you can adjust the CE Smith Narrow V-Wing Bolster Bracket for Pontoon Boat Trailers # CE26265G40 along the frame.

expert reply by: Kyle S

0

Answer 1

Tire size 4.80-12 is not found on vehicles, but is a common trailer tire size on smaller utility- and sport-type trailers. In trailer use you do want to inflate them to the maximum cold psi pressure noted on the tire sidewall. Trailer tires should…

view full answer...

Answer 2

With trailer tires like #AM30670 you have to run the max tire pressure rating that's on the sidewall of the trailer. This ensures you get the full weight capacity of the tire and also that you prevent any heat build up which also leads to…

view full answer...

Answer 3

You always want to keep your trailer tires psi set to what is recommended. If the psi is higher or lower then the tire will not perform as the manufacturer states. For instance, the Kenda #AM30670 is rated for 990 lbs at 90 psi. If we were to deflate…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

Great question, William! The Karrier ST225/75R15 #KE63KV is a KR35 while the Karrier ST225/75R15 #AM10303 is a KR03 according to Kenda. There is a slight variation in the tread pattern and from what Kenda says about them it looks like the KR03 is…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Can CE Smith Narrow V-Wing Bolster Bracket be Shifted

Product Page this Question was Asked From

Continue Researching