Removing Brake Controller from 2006 Winnebago Voyage on F-53 Chassis
Updated 08/07/2023 | Published 08/06/2023
Question:
I have a 2006 Winnebago Voyage on the F 53 chassis. On the drivers side there is an electric box with 4 wires attached. What is it and how do I move it out of the way of the upper mounting bracket?
asked by: Roland J
0
Expert Reply:
It sounds like what you have is a brake controller that you are looking to have removed. All you would have to do is unbolt it from your dash, cut the wires, and then tape them up and you'd be set.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Heavy Duty
- Rear Axle Suspension Enhancement
- Firestone
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Timbren TFRF53A Install Issue On Ford F53 With Limited Driver Side Clearance
- Q&A: What Are The Benefits Of Airbags With And Without Internal Jounce Bumpers?
- Article: How to Set the Right PSI for Your Air Bags
- Q&A: Will Air Lift Front Air Bags Limit Use of Jacks on Ford F-53
- Q&A: Recommendation to Reduce Sag on Left Side of Class C Motorhome without Using Air Bags
- Q&A: Will Air Bags Allow 2004 Ford F-53 Motorhome to Raise 4 Inches
- Q&A: Suspension Enhancement for a Motor Home Built on a 2011 Ford F-53 Chassis
- Q&A: Front Air Bag Suspension Kit that Fits 2003 Workhorse RV Chassis
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Tow Dolly vs Flat Towing vs Trailer Towing
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Stability Control for Heavy Duty Vehicles
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer