Keel Roller for 1975 Wellcraft V20 Boat Trailer
Published 07/06/2023
Products Featured in This Question
Question:
I have a 1975 Wellcraft V20 step lift. I just bought a used trailer with no keel rollers. There are 4 cross members, stern cross member and the bow cross member. What type rollers would you recommend and do you recommend a roller for each cross member? I replaced the bunks, but placement and height were a guestament. Is there a guide to where/how the bunks should be placed?
asked by: Chris
Expert Reply:
For the crossmembers the CE Smith Deep V Keel Roller Assembly part # CE10403G would work really well. It's pretty common to use one of these on each crossmember so it would work pretty well. Then for U-bolts you'd want the part # CE15283GA-4.
Product Page this Question was Asked From
CE Smith Deep V Keel Roller Assembly for Boat Trailers - Galvanized Steel/Black Rubber - 8"
- Boat Trailer Parts
- Rollers
- Keel Roller
- Rubber
- 8 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: What Size Lag Bolts do I Need to Swap Out Bunk Boards on 20 Foot Bass Boat?
- Q&A: Can the Yakima Holdup # Y02433 Be used with Bikes that Have Fenders
- Q&A: Recommended Roller Bunks Replacement for Wooden Bunks for G3 1860 Boat
- Q&A: Can Bunk Boards Longer Than 69-1/2" be Installed on a Boat Trailer
- Q&A: How Long of Lag Bolts Should I Use w/ the CE Smith Bolster and Swivel Bracket Assemblies?
- Article: Trailer Tire Sizing
- Q&A: How to Determine if a Torsion Axle Needs to be Replaced and Lifting a Trailer Off the Ground
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Tell the Weight Rating of a Trailer Axle