Is 4-Bolt Brake Flange Needed to Install 3,500 lb Hub & Drum AKHD-655-35-K
Updated 06/27/2023 | Published 06/25/2023
Products Featured in This Question
Question:
I’m rebuilding a 1970s Manorette camper. # AKHD-655-35-K has the dimensions I need. My existing hum and drum assembly has a four bolt pattern to attach it to a plate on the back side. I did not see this called out on the website. Do I need to use them?
asked by: Joe
Expert Reply:
Good question but no, the 4-bolt brake flange is not a requirement to install the Trailer Hub and Drum Assembly - 3,500-lb Axles # AKHD-655-35-K.
The hub will still fit your spindle and install just fine, but you will need that 4-bolt brake flange if you were also installing brakes that fit the hub like the Dexter Hydraulic Trailer Brake Kit # 23-312-313 or Dexter Electric Trailer Brake Kit # 23-26-27.
(click to enlarge)
Product Page this Question was Asked From
Dexter Hydraulic Trailer Brakes - Uni-Servo - 10" - Left/Right - 3.5K
- Trailer Brakes
- Hydraulic Drum Brakes
- Standard Grade
- Manual Adjust
- Single Servo
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Shop: Dexter Trailer Hub and Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2
- Shop: Dexter Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3.5K
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: etrailer Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3,500 lbs
- Shop: Ladder Rack
- Shop: Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Search Results: trailer brake wiring
- Search Results: bk2~100
- Search Results: trailer brake controller
- Search Results: 12 gauge wire
- Q&A: Parts Needed To Add Electric Drum Brakes To A Trailer
- Q&A: Replacement Dexter Electric Trailer Brakes For 3,500 lb Axle
- Q&A: Parts Needed To Add Electric Brakes Onto a 3,500LB Dexter Axle Without Brakes
- Q&A: Replacement Hub/Drum and Brake Assemblies for AL KO 4,400 lb Trailer Axle
- Q&A: Recommended Brakes and Hubs for a Dexter 3,500 lbs Axle
- Q&A: Recommended Replacement Electric Brake Assembly for 3500 Pound Dexter Axle, 10 x 2-1/4 Inch Drum
- Search Results: akhd~545~35~ez~k
- Video: What to Know About the Demco Hydraulic Brake Actuator-DM72VR
- Shop: Brake Controller
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Shop: TruRyde Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Shop: Mounting Hardware for 10" Brake Assemblies