Are There Replacement T-slot Rails For RetraxOne Retractable Tonneau Cover On 2010 Dodge Ram 1500  

The correct grease seals and bearings for the Dexter 8437302 is as follows: Inner bearing #L68149 Outer bearing #LM67048 Grease seal #RG06-050 For replacement hub we have the #8-407-5UC3-EZ which includes all of the above components so you do not…

If your trailer's brakes remain engaged when it is plugged in to your vehicle, even when the controller does not indicate that it is generating a brake signal, this most often means that there is a short in the vehicle's or trailer's…

I spoke with Retrax and you can indeed replace the rails on your RetraxPRO MX Hard Tonneau Cover #RT80232 with something that has the T slots. As you have a 2012 Ram 1500 with the 6-1/2 foot bed and no RamBox, you will need the Replacement Side Rails…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

Hello Brian; the 3/8" difference isn't enough to matter so you can use the #e89FV as a replacement. We do have the U-Bolt Kit for Mounting 5,200-lb to 7,000-lb Round Trailer Axles #APUBR-8 for 3" diameter axles. This has 7" long…