Is Any Trimming Needed to Install Curt Trailer Hitch on 2004 Dodge Durango
Updated 06/19/2023 | Published 06/16/2023
Products Featured in This Question
Question:
Do I need to cut into trim bumper?
asked by: Rene
0
Expert Reply:
I took a look at the directions for you, and am happy to report no type of cutting or trimming is needed on your 2003 Dodge Durango to install the Curt Trailer Hitch Receiver # 13297.
This is an easy bolt-on install and no drilling is necessary either. I also wanted to mention that if you plan on towing with your Durango and need a wiring harness the correct part is the Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C55597.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 9000 lbs WD GTW
- 2 Inch Hitch
- 900 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Replacement For A Trimark 030-1000 RV Entry Door Lock
- Q&A: Is there a Hitch and 4-Way Trailer Wiring for a 2026 Mazda CX-5?
- Q&A: Can EcoHitch EH66SR For 2025 Ford Mustang Mach E Carry 200 lbs Of Tongue Weight?
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Trailer Hitch for a 2005 Dodge Durango
- Q&A: Recommended Stabilizer Jacks To Replace PJ-01 Corner Post Stabilizer Jack on 2022 Forest River NOBO
- Q&A: How to Position the Lippert Shocks on a Single Axle Trailer
- Q&A: How to Determine Load Carrying Capacity of 2005 Dodge Durango
- Article: How to Choose the Right Trailer Hitch Class