Replacement Beehive LED Marker/Clearance Lights With Grommets

Question

Question:

Need 2 behive led marker lights with gromets

asked by: Clifton E

0

Expert Reply:

We have the Optronics LED Trailer Clearance Beehive Light in Amber # MCL21AB or Red # MCL21RB. These both fit inside the Grommet # A54GB.

expert reply by: Bud M

0

Answer 1

You are correct, the Replacement Tail Block Locking Assembly #8880334 is only for the 2015 and up model year Rack and Roll trailers. According to Yakima, the reason is the thickness and length of the shaft was increased, so it's a different size.…

view full answer...

Answer 2

The most likely cause for the turn signals not to work when the running lights are on with your trailer is a bad or weak ground. It's very possible that a weak ground connection can be just strong enough to allow sufficient current for some…

view full answer...

Answer 3

Yes, so long as your Rack & Roll trailer is from 2015 or newer, you can replace the lever's locking pin assembly so you don't have to get the entire Replacement Center Frame Rail #8880727. The correct replacement part is the following: -…

view full answer...

Answer 4

I'm sorry to hear about the troubles you're having with your Yakima Rack and Roll Trailer #Y08107! However, the small light at the end of the frame rail is actually not replaceable. It comes as part of the entire left or right side frame rail…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Replacement Beehive LED Marker/Clearance Lights With Grommets

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching