Bearing Buddy Bearing Protectors For a Utility Trailer With 2-1/16" OD Grease Cap
Published 06/09/2023
Products Featured in This Question
Question:
Im looking for a Bearing Buddy for my utility trailer. The existing cap, measured with a ruler, is 2-1/16 OD. Is there such a product? This is a home-made trailer from an old car or truck rear end.
asked by: Eric R
Expert Reply:
To verify the correct Bearing Buddy bearing protectors to replace your grease cap you will want to remove one of your caps and measure the inside diameter of your hub bore using a Digital Caliper # PTW80157. This will help you verify the exact measurement needed for hub. Here is a list of the closest sizes we have to the 2-1/16" you measured with a ruler.
1.980" Hub Bore # BB1980A-SS
2.047" Hub Bore # BB2047SS
2.080" Hub Bore # BB2080SS
Product Page this Question was Asked From
4" Carbon Fiber Digital Caliper
- Hand Tools
- Measuring and Layout Tools
- Digital Calipers
- Carbon Fiber
- Performance Tool
more information >
Continue Researching
- Q&A: Recommended Bearing Kit for a 3,500 lbs Axle on a Boat Trailer
- Q&A: How to Determine the Replacement Hubs for a 2002 Magic Tilt Trailer
- Q&A: Kodiac Disc Brake Kit Compatibility with UFP DB-42 Axle
- Q&A: Diameter of Spindle Washer # SW1000 and Wobble Roller Retainer Ring CE10981
- Q&A: How to Choose the Correct Size Trailer Winch For a Boat Trailer
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Will Installing Trailer Hitch on 2020 Nissan Murano Keep Hands Free Liftgate From Working
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Troubleshooting Trailer Bearings that Fit Almost Too Tight to Install
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements