Does Weight Distribution System Need Adjusting if Suspension Enhancement Has been Installed
Published 06/07/2023
Question:
Hello, I recently installed timbrens on my truck. My question is if my camper will sit a little bit higher, what would i need to adjust on my WDH? Would it be just something on the head? the L brackets? or both? My WDH is part# RE94FR. Thanks
asked by: Brent U
Expert Reply:
You would need to lower the spring bar tension a little bit since you have Timbrens now on your truck. Since you have the Reese Round Bar WD system part # RE94FR this will be done by changing the angle of the head of the system using the washers that are in the head. You will end up going with fewer washers in the head to accomplish this. If you check out the attached install instructions you will see how to do this.
Continue Researching
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Can Trailer Be Backed Up While Connected to Reese Pro Round Bar Weight Distribution
- Article: Determining Trailer Tongue Weight
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Q&A: Can Reese 49912 Weight Distribution Hitch Part RE94FR Be Used With A 2" Hitch Ball?
- Q&A: Can Trailer Be Backed up with Reese Round Bar Weight Distribution System Connected
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Trying To Decide Between Reese Dual Cam II And Reese Strait Line
- Q&A: Will Friction Sway Control Stop Swaying Trailer that Already has Weight Distribution
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Can Reese Pro Round Bar Weight Distribution System Be Backed Up With
- Q&A: Recommended Weight Distribution Hitch For Trailer W/ 440lbs TW, and Trailer W/550lbs TW