Mounting Hole Diameter for a Rubber Bumper for Enclosed Trailer Ramp Door

Question

Question:

Rubber Bumper for Enclosed Trailer Ramp Door - 2-1/2 Diameter Item # 37210715 I was wondering if you carry one of these with a 1/4 inch mount hole

asked by: Austin K

1

Helpful Expert Reply:

We have a couple of options for rubber bumpers but neither one of them has a 1/4" mounting hole. You can use a washer and install the Rubber Bumper for Enclosed Trailer Ramp Door item # 37210715 you were looking at.

The other option is the Redline 1" Item # 386000 which has a 1/8" mounting hole.

expert reply by: Jerred H

1

Answer 1

I checked your order notes and the part number you ordered was 385800 which is no longer available but the part #37210715 is essentially the same thing so it would work just as well if not better.

view full answer...

Answer 2

The Rubber Bumper for Enclosed Trailer Ramp Door #37210715 can fit a washer with a 1" outer diameter and 3/8" inner diameter. The bolt can be anything 3/8" in diameter or smaller and the length is going to depend on how thick of a ramp…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Dustin. I installed the Enclosed Trailer Transition Plate item #M368FR on a trailer here when we first got them in and you're good! That plate is single solid piece of steel. It's got a heavy duty piano style hinge that has been riveted…

view full answer...

Mounting Hole Diameter for a Rubber Bumper for Enclosed Trailer Ramp Door

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching