Replacement Brake Assemblies for Dexter 10k Trailer Axle
Published 05/17/2023
Products Featured in This Question
Question:
Hello, I have previously used the dexter brand 12 1/4 4 inch electric brake on my 10k dexter axle, can I use your AKEBRK-10R and 10L as a replacement, if so what is the main difference besides width, thanks
asked by: Victor H
1
Helpful Expert Reply:
Yes, for your Dexter 10k axles you can use the 10k brake assemblies part # AKEBRK-10R and # AKEBRK-10L that you mentioned. These were designed for your Dexter 10k axles and the slight narrower width would not be an issue at all.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Electric Trailer Brake with Dust Shield - Self-Adjusting - 12-1/4" - Right Hand - 10,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- RH
- 10000 lbs
- Brake Assembly
- Self Adjust
- 12-1/4 x 3-3/8 Inch Drum
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Shop: Grease Seals 10-36 (pair)
- Shop: Electric Trailer Brake Assembly - Self-Adjusting - 12" - Right Hand - 5,200 lbs to 7,000 lbs
- Q&A: Installing the Magnet Retainer Clip on a 10K Electric Brake
- Shop: etrailer Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 5,200 lbs to 7,000 lbs
- Article: Where to Position the Trailer Axle?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Search Results: magnet clips
- Q&A: How to Find Bearing and Seal Part Numbers for 1994 Airstream Triple-Axle Trailer
- Video: etrailer Easy Grease Trailer Hub and Drum Assembly Installation - 2019 Grand Design Reflection 150 F
- Video: Easy Grease Trailer Hub and Drum Assembly for 5.2K & 6K Axles: The Breakdown
- Shop: Replacement Magnet Retaining Clips for 10" and 12" Electric Trailer Brakes - Qty 10
- Shop: Easy Grease Trailer Hub and Drum Assembly for 5.2K & 6K Axles - 12" - 6 on 5-1/2 - Pre-Greased
- Q&A: Installing Castle Nut in Hub and Drum Assembly
- Q&A: Torque for 7,000 lb, 12 Inch x 2 Inch Dexter Electric Brakes
- Q&A: Clip that Holds Trailer Brake Magnet to Assembly
- Q&A: Torque Spec for Tightening Trailer Brake Assemblies to Trailer Spindle
- Q&A: What Causes a Brake Magnet To Fall Off After Removing the Hub
- Shop: Grease Seal - Double Lip - 2.250" ID - 3.376" OD - GS-2250DL
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Video: A Closer Look at the 7-Piece Installation Set for Bearings, Races, and Seals
- Video: All About the Grease Seal
- Video: Inspecting and Packing Trailer Bearings with Grease Demonstration
- Video: Remove, Inspect, and Reinstall Trailer Bearings, Race, and Seals Demonstration