Correct Motor Support Toggle That is 4-1/2" Long and 1-1/2" Wide for a Worn Transom Saver
Updated 05/17/2023 | Published 05/15/2023 >
Question:
I have a worn-out transom saver for my pontoon boat. The only thing left on the unit is - Ayoid. I need the replacement part that has the rubber bumpers on the end piece that connects to the motor. Mine is 4.5 long and 1.25 wide. Your thoughts on the replacement parts? Tx
asked by: Rick S
Expert Reply:
What you're needing is the Replacement Motor Support Toggle for Jif Marine Transom Saver # 315-FXL.
This part measures 4-1/2" long, 1-9/32" wide (1/32" larger than what you measured), and is made from a cast iron body which is corrosion resistant.
Also, this part does come with replacement mounting hardware so you won't have to worry about getting that as well.
Product Page this Question was Asked From
Replacement Motor Support Toggle for Jif Marine Transom Saver
- Accessories and Parts
- Boat Motor Accessories
- Motor Support Toggle
- Jif Marine
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Motor Support Toggle For Old Transom Saver
- Q&A: Recommended Leaf Spring Replacement For A 1999 MFI Boat Trailer
- Q&A: Recommended Low Profile 15" Tire for Boat Trailer
- Q&A: Trailer Tire Recommendation with Smaller Diameter than 225/75-15 Fits Same Wheel
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Q&A: Replacement Hub/Rotor and Bearings for Tie Down Engineering TDE46245
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer


