Correct Replacement Anode Rod for a Suburban Water Heater
Updated 05/05/2023 | Published 05/03/2023
Question:
My Suburban hot water heater anode needs replaced. The threads on the tank are rusted/corroded and need to be cleaned up before intalling new anode rod. Wire brush doesnt get it. Ive read that it is 3/4 NTP but when I try to find a thread chaser, all I find is 14 thread inch chasers but I think the anode is 12 thread inch. Do you have a thread chaser available? Thank for your help
asked by: Larry D
Expert Reply:
The 14 thread inch chaser will work just fine for you as the Camco RV Water Heater Anode Rod # CAM11563 that you'll need for your Suburban water heater is 9-1/2" long with 3/4"-14 NPT pipe threads, so you're good to use the 14 thread inch chaser.
Product Page this Question was Asked From
Camco RV Water Heater Anode Rod - Aluminum - 3/4" Diameter x 9-1/2" Long
- Accessories and Parts
- RV Water Heater
- Anode Rods
- 3/4 Inch Diameter
- Aluminum Rod
- 9-1/2 Inch Long
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Anode Rod Replacement Does Suburban SW6DE Take
- Q&A: Low Profile Replacement AC for 2018 Forest River Travel Trailer
- Q&A: What is the Maximum Length for a Propane Hose
- Q&A: What To Do If My Vent Lid Is Hitting The Vent Cover?
- Q&A: Replacement Air Conditioner for RV Duo Therm 57915.531
- Q&A: Replacement Anode Rod for Suburban SW10DE Water Heater
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: How To Use a Roof Vent Cover With An Auto Open Roof Vent
- Article: Can You Flat Tow a MINI Cooper?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Install an RV Awning From Scratch
- Article: How to Replace a Rubber RV Roof
- Article: How to Measure Your Trailer Wheel Bolt Pattern