What Order Do the Washers Go on the Optronics Single Face Trailer Tail Light
Updated 05/03/2023 | Published 05/02/2023 >
Question:
I just received the Optronics Pedestal Mount lights,very nice. The lights came with a rubber grommet a lock washer and nut.In what order should I install these? Thanks
asked by: Steve
Helpful Expert Reply:
In regards to the Optronics Single Face Trailer Tail Light part # ST51RB, the post will install into the hole first without any hardware underneath. Then, you'll place the flat washer followed up by the lock washer and nut. It will be the same as the order of the hardware shown in the photo below.
I don't see any rubber grommets on my end but if I had to guess I would say it goes between the light base and mounting hole.
Product Page this Question was Asked From
Optronics Single Face Trailer Tail Light - Stop, Turn, Tail - Round - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Pedestal Mount
- Non-Submersible Lights
- Incandescent Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Can I Swap Out Kodiak Rotors w/ DeeMaxx Ones?
- Q&A: Replacement Entry Door Lock for 2022 Venture SportTrek Touring STT343VIK
- Q&A: Replacement Water Valve for Dometic 310 Toilet
- Q&A: How To Wire Optronics Pedestal Mount 3-Function Tail Light # ST51RB to Utility Trailer
- Q&A: Recommended Replacement AC System for a GE ARH15AACBL2 AC Unit
- Q&A: Method for removing and Installing Tang-Style Spindles Washers
- Q&A: Replacement Grease Seal for Timken 171255
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Types of Bumpers
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)


