What are the Dimensions of the Trailer D-Ring Tie Down # SR15-C
Updated 02/14/2014 | Published 02/13/2014
Question:
WHAT IS THE MEASUREMENT OF THE MOUNTING HOLES, CENTER TO CENTER? HOW WIDE IS THE MOUNTING STRAP?
asked by: STAN S
1
Helpful Expert Reply:
We have a lovely diagram showing the measurements you need for Trailer D-Ring Tie Down # SR15-C. I have reproduced it for you here.
The width of the strap part is 1-3/16 inches. And the mounting holes are 2-1/4 inches apart on center.
expert reply by:
Michael H
1
click to enlarge
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 3-1/2" Wide - Surface Mount - 1,600 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 1600 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Continue Researching
- Q&A: Difference Between Pro Series Drop Leg Square Jacks PS1400950376 And PS1400960376
- Q&A: Where do I Install D-Ring Tie Downs on a 6x10 Wood Bed Utility Trailer
- Q&A: Recommended Replacement Tail Lights For Obsolete KD 460 Tail Light Lenses On Hay Bale Truck
- Q&A: Recommended Replacement Jack For Shelby Bolt On Boat Trailer Jack
- Article: Cargo Tie-Down Methods
- Q&A: Recommendation for Re-Using Deck Board Screw Holes When Replacing Wood on Trailer
- Q&A: How to Wire the Dexter Electric Over Hydraulic Trailer Brake Actuator
- Q&A: How To Power Third Brake Light On Camper Shell Using 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Basics of Tie-Down Anchors