Are Wire Harnesses For The Jensen AWM910 And JWM62A The Same
Updated 04/26/2023 | Published 04/25/2023 >
Question:
Are the wiring harness the same between the JWM62A and the AWM910
asked by: Lawrence A
Expert Reply:
No, RV stereo manufacturers use different wiring harnesses for each stereo so you will have remove your old AWM910 wire harness and splice in the new # JWM60A wire harness. I've found that it's much easier to do if you get wiring diagrams for both units and then slowly swap each speaker over to the new wire harness.
I've attached a video below of another stereo I installed that will show you this exact procedure starting at the 5:20 minute mark. I've also attached the wiring diagrams for both stereos to make the transition easier.
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Best Replacement for a Jensen RV Stereo AWM910
- Q&A: Wiring Instructions For The Jensen JWM62A RV Stereo
- Q&A: Recommended Replacement Stereo for Jensen AWM970
- Q&A: Best Replacement for Linear Series RV5090 RV Stereo
- Q&A: Recommended Replacement For A Magnadyne RV5090 RV Stereo System
- Q&A: Recommended Replacement for Old Jensen JWM6A RV Stereo
- Q&A: Recommended Replacement For An Estone RX8500 RV Stereo
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: How to Raise Your Travel Trailer Height
- Article: How Much Solar Power Do I Need For My RV?
- Article: Which RV Propane Tank Size Do I Need?
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes


